General Setup; Battery Installation; Battery Disposal - Harman Kardon GO+PLAY Micro Guia Del Usuario

General Setup

Unpack the Harman Kardon Go + Play Micro System and Its Power Supply
1. Plug the adapter into the 24V DC IN port
2. Turn on the power button on the top of the unit. The white indicator light will turn on.
3. Remove the remote control battery protector before operating the remote control.
1.
Volume Control (On-base Unit)
Volume increase
Volume decrease
0204CSK - HK Go+Play Micro OM V1.indd 4
on the back of the unit and then into a wall outlet
2.

Battery Installation

1. Unscrew the two battery compartment cover screws counterclockwise to the unlocked
position; remove the battery compartment cover.
2. Place eight (8) fresh C-cell batteries as shown.
3. Replace the battery compartment cover.
Note: System will not use battery power when using AC power.
2.
3.
DO NOT MIX BATTERY TYPES.
DO NOT MIX CHARGED AND PARTIALLY CHARGED BATTERIES.
BATTERIES WILL NOT RECHARGE WHILE IN THE UNIT

Battery Disposal

Alkaline batteries are considered nonhazardous. Rechargeable batteries (i.e., nickel cadmium, nickel metal-
hydride, lithium and lithium-ion) are considered hazardous household materials and may pose an unnecessary
health and safety risk.
In the European Union and other locations, it is illegal to dispose of any battery with household trash. All batteries
must be disposed of in an environmentally sound manner. Contact your local waste management officials for
information regarding the environmentally sound collection, recycling and disposal of used batteries.
4
1.
24/03/10 9:38:42