Publicidad
16. Code selection
After selecting a code system, the related operations of all editing sys-
tems are only valid on the barcode of the code system. The default setting
is all selection.
Setting method: enter the setting - read "code system selection" - select
the corresponding code system identity characters - exit the settings.
Cancel method: enter the setting - read "code system selection" - exit the
setting, then you can cancel all previous selections.
(Code ID characters are shown in Appendix D - check our website)
17. Prefix/suffix settings
Prefix settings:
Go to Settings - Read "Set Prefix" - Read Content (can be full ASCII, up
to 10 digits) - Exit Settings
Prefix cancel:
Go to Settings - read "Set Prefix" - Exit Settings
Suffix settings:
Enter settings - read "set suffix" - read content (can be full ASCII, up to 10
digits) - exit settings
Suffix canceled:
Enter settings - read "set suffix" - exit settings
Code selection
Set prefix
19
Publicidad
