Cleaning The Oven - GE JGBS10DEFBB Manual Del Propietário

Cleaning The Oven

Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
Control Panel and Knobs
Wipe the control panel after each use of the oven with
a damp cloth. For cleaning, use mild soap and water or
a 50/50 solution of vinegar and water. Rinse with clean
water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control
panel—they will damage the finish.
Do not try to bend knobs by pulling them up or down or
by hanging a towel or other such loads. This can damage
the gas valve shaft.
The control knobs may be removed for easier cleaning.
With knobs in the OFF position pull them straight off the
stems.
The knobs can be washed by hand with soap and water
or in a dishwasher.
Oven Exterior and Cooktop Surface
Do not use oven cleaners, abrasive cleansers, strong
liquid cleansers, steel wool, plastic scouring pads, or
cleaning powders on the interior or exterior of the oven.
Clean with a mild soap and water or a 50/50 solution of
vinegar and water. Rinse with clean water and dry with a
soft cloth. When cleaning surfaces, make sure that they
are at room temperature and not in direct sunlight.
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
Cleaners with oxalic acid such as Bar Keepers Friend Soft
Cleanser™ will remove surface rust, tarnish and small
blemishes. Use only a liquid cleanser free of grit and rub in
the direction of the brush lines with a damp, soft sponge.
To inquire about purchasing cleaning products including
stainless steel appliance cleaner or polish, read the
Assistance/Accessories sections at the beginning of this
manual.
Oven Interior
The interior of your new oven can be cleaned manually
or by using the Steam Clean or Self Clean modes.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up as soon as hot surfaces cool,
then clean and rinse.
49-85209-6
Not all knobs are interchangeable. To determine the
correct location of a particular knob, examine the back of
the knob. A knob with a label or two stem holes should
be replaced on the front panel first by matching the
shape of the knob holes to the shape of the control panel
stems. The remainder of the knobs having no labels and
only one stem hole can then be replaced on the front
panel anywhere there is a single stem.
Surface burner knob
If a stain on the door vent trim is persistent, use a mild
abrasive cleaner and a sponge-scrubber for best results.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up immediately. Let hot surfaces
cool, then clean and rinse.
For easier cleaning, the control knobs may be removed
by pulling them directly outwards once the knobs are in
the OFF position. Do not pull knobs up or down or hang
objects on them. This can damage the gas valve shaft.
The knobs can be washed by hand with soap and water or
in a dishwasher.
To replace knobs after
cleaning, align the hole on
the knob backside with the
gas valve shaft and push
inward until the knob is
securely fastened.
Manual Cleaning
Do not use oven cleaners, abrasive cleaners, strong
liquid cleansers, steel wool, scouring pads, or cleaning
powders on the interior of the oven. Clean with a mild
soap and water or 50/50 solution of vinegar and water.
Rinse with clean water and dry with a soft cloth. When
cleaning surfaces, make sure that they are at room
temperature and not in direct sunlight.
Label
Stem
Stem
holes
Knobs with two stem holes have
special locations
Surface burner knob
17