Package Contents; Description (Fig. A); Electrical Safety - DeWalt DC980 Manual Del Usuario

E N G L I S H
Do not incinerate the battery pack
NiMH, NiCd+ and Li-Ion.
Charges NiMH and NiCd
battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.

Package contents

The package contains:
1 Cordless midhandle driver/(percussion) drill
1 Charger
1 Battery pack (K and A1, B1, L1 models)
2 Battery packs (KA, KB, KL and K2 models)
1 Side handle (DC987KL/DC988KL)
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

WARNING: Never modify the power tool
or any part of it. Damage or personal
injury could result.
INTENDED USE
Your cordless driver/(percussion) drill has been
designed for professional drilling and screwdriving
applications.
DO NOT use under humid conditions or in presence
of flammable liquids or gases.
These drills are professional power tools. DO NOT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
1 Variable speed switch
2 Forward/reverse slider
3 Keyless chuck/auto spindle lock
4 Mode selector/torque adjustment collar
5 Collar settings
6 Three-gear selector
7 Bit holder
34
8 Grip
9 Side handle (DC987/DC988)
10 Battery pack
11 Release buttons
12 Charger
13 Charging indicator (red)

Electrical Safety

The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
DANGER:
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminals crews.