+40 ˚c
+4 ˚c
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
Package contents
The package contains:
1 Cordless midhandle drill/driver
1 Battery charger
1 Battery pack (K models)
2 Battery packs (K2 models)
1 Screwdriver bit
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your cordless drill/driver DW952/DW953/DW954/
DW958 has been designed for professional drilling
and screwdriving applications.
1 Variable speed switch
2 Forward/reverse switch
3 Keyless chuck
4 Mode selector/torque adjustment collar
5 Collar settings
6 Two gear selector
7 Bit holder
8 Grip
9 Battery pack
Charger
Your DE9107 charger accepts D
battery packs ranging from 7.2 V to 14.4 V.
Your DE9108 charger accepts D
battery packs ranging from 7.2 V to 18 V.
9 Battery pack
10 Release buttons
19
All manuals and user guides at all-guides.com
11 Charger
12 Charging indicator (red)
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
power corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Mains plug replacement
(U.K. & Ireland only)
WALT NiCd
E
WALT NiCd
E
Your D
WALT charger is double
E
insulated in accordance with EN 50144.
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D
WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
E N G L I S H
.
en - 4