Gima 32702 Manual De Instrucciones página 6

• Now, stop inflation and screw the deflation button gently with thumb so as to
get the pressure drop slowly and steadily at about 2-3 mmHg per second. Listen
and watch the dial plate carefully during deflation, the point at which repetitive,
clear tapping sounds first appear for at least two consecutive beats gives the
systolic blood pressure. The point where the repetitive sounds finally disappear
gives the diastolic blood pressure;
• After you get the diastolic pressure, screw the deflation button to the end for
rapid deflation;
• Remove the stethoscope and cuff from arm after the pressure in the cuff bot-
toms out.
• Care, Maintenance, Calibration and Warranty
This instrument may be used only for the purpose described in this booklet.
The manufacturer cannot be held liable for damage caused by incorrect applica-
tion. This instrument comprises sensitive components and must be treated with
caution. Observe the storage and operating conditions described in the Specifi-
cations section .
Protect it from:
• Overladen inflation more than 300 mmHg
• Water and moisture
• Extreme temperatures
• Impact and dropping
• Contamination and dust
• Direct sunlight
• Cleaning the cuff
The cuffs are sensitive and must be handled with care. You can clean the cuff
cover with damp cloth.
WARNING: Under no circumstances may you wash the inner bladder!
ATTENTION: Sterilization is not necessary since the parts of manometer should
not come into direct contact with the patient's body during measurement.
• Calibration
The device must be calibrated for the sake of reliable performance and accuracy.
Thus, we kindly recommend a fixed check of static pressure display per 2 years.
Consult the dealer for more information on it.
ENGLISH
6