Safety Instructions; Installation And Connection - TECshow PAR 1000Z Manual De Usuario

2. SAFETY INSTRUCTIONS

Please read the instruction carefully
which includes important informa-
tion about the installation, usage
and maintenance.
• Please keep this User Manual for future con-
sultation. If you sell the fixture to another user,
be sure that they also receive this intruction
booklet.
• Please unpack and check carefully there is no
transportation damage before using the fixture.
• Please disconnect main power before servicing
and mantenance.
• The unit must be installed in a location with ad-
equate ventilation, at least 50cm from adjacent
surfaces.Be sure that no ventilation slots are
blocked.
• The maximum ambient temperature is Ta:40°C.
Do not operate it where the temperature is
higher than this.

3. INSTALLATION AND CONNECTION

The unit should be mounted via its screw holes on
the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operat-
ing. Always ensure that the structure to which you
are attaching the unit is secure and is able to sup-
port a weight of 10 times of the unit's weight. Also
always use a safety cable that can hold 12 times of
the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And
it must be fixed at a place where is out of the touch
of people and has no one pass by or under it. The
unit should be mounted in the height of 0 to 30m.
• Do not connect the device to any dimmer pack.
• The housing must be replaced if they are visibly
damaged.
• Unit surface temperature may reach up to 85°C.
Don't touch the housing bare-hand during its
operation. Turn off the power and allow about
15 minutes for the unit to cool down before
replacing or serving.
• There are no user serviceable parts inside the
fixture. Do not open the housing or attempt any
repairs by yourself. In the unlikely event your
fixture may require service, please contact your
nearest dealer.
• In the event of serious operating problem, stop
using the fixture Immediately. Never try to
repair the fixture by yourself. Repairs carried
out by unskilled people can lead to damage or
malfunction. Please contact the nearest au-
thorized technical assistance center. Always use
the same type spare parts.
P. 3
| Tecshow Par 1000Z
English version