Getting To Know Your Dishwasher; How To Fill The Salt - Haier DW12-PFE1 Manual Del Usuario

Getting to know your dishwasher

Close-up view (control panel)
A
A
ON-OFF Button
B Programme Button
Models explanation
Model
DW12-PFE1
DW12-PFE1ME
DW12-PFE1SS
You can select dishwasher with big handle or without big handle according to
requirement.

How to fill the salt

Salt
The hardness of the water varies from place to place. If hard water is used in
the dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically
designed to eliminate lime and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as
follows:
According to the "Water Hardness Tabel", you can calculate the time of
use , then load the salt .
Remove the lower rack and then unscrew and remove the cap from the salt
container.
If you are filling the container for the
first time, fill it with water.
Place the end of the funnel (supplied)
into the hole and introduce about 2 kg
of salt. It is normal for a small amount
of water to come out of the salt container.
Carefully screw the cap back on.
Important
To prevent the formation of rust, load the salt just
before beginning a wash cycle.
C
B
C
Programme Indicator
Colour
White
Silver
Stainless Steel
Dishwasher interior
a
c
b
Upper Rack
a
b Lower Rack
c Top Spray Arm
d Silverware Basket
e Third Sprayer
f Bottom Spray Arm
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed
based on the hardness of the water used. This is intended to optimize and cus-
tomize the level of salt consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see figure to the side).
If necessary, rotate the ring in an anticlockwise direction from the "-" set-
ting towards the "+" sign, based on the hardness of the water being used.
It is recommended that adjustments be made in accordance with the following
table:
Water Hardness
Clarke
º
Level dH
mmol/l
degrees
1 0 14
M NT M NIT
2 NQ PS NU QQ NIU QIQ
3 PS TN QR UV QIR UIV
4
[TN [UV [UIV
e
f
g
d
h
i
Salt Container Cap
g
h Washing Filter
Detergent and Rinse Aid Dispenser
i
Water Inlet Hose (some models with "Aquastop")
j
Drain Hose
k
Power Supply Cord
l
Salt
Selector
c o n s u m p t i o n
position
(Grams/cycle)
L M
=?J? OM
jba QM
?H? SM
EN
j
k
l
Autonomy
(cycles/2kg)
L
SM
QM
OR
4