MHZ PowerView Surface Kit Manual De Instrucciones página 26

Vertical Blind Programming Guide
PowerView® I
Set end positions (set open end position)
+
26
Press Stop button for 6 seconds
(do not select a channel button
on the remote control unit)
Press Motor button and keep
pressed.
Additionally, within 3 seconds,
briefly press Open button .
Release Motor button.
If the buttons are still flashing,
the remote control unit is still in
'Teach-in Readiness' mode.
Press Stop button for 6 seconds
or wait for 20 seconds.
The open end position has
been set.
Button lighting on the
trans mitter flashes.
Teach-in readiness
established.
Blind briefly moves once.
Button lighting on the
trans mitter stops flashing.
Teach-in readiness ended.
To set the open end
position again, repeat the
steps.