MHZ PowerView Surface Kit Manual De Instrucciones página 30

Vertical Blind Programming Guide
PowerView® I
Integrate new transmitter into existing network
+
30
Press P button on the new
transmitter for 6 seconds.
Press Stop button on the
known transmitter for
6 seconds.
Press Stop button on the new
transmitter and keep pressed.
Additionally, within 3 seconds,
briefly press Stop button on the
known transmitter.
Press Stop button on the known
transmitter for 6 seconds or wait
for 20 seconds
Channel buttons on the new
transmitter flash after 3 and
6 seconds. Transmitter is in
programming mode.
Button lighting on the
transmitter flashes.
Teach-in readiness
established.
Channel buttons on the new
transmitter flash twice.
ID has been copied to the new
transmitter.
Button lighting on the
transmitter stops flashing.
Teach-in readiness ended.