MHZ PowerView Surface Kit Manual De Instrucciones página 31

LED Motor Indicator Light
PowerView® I
The motor indicator light shows the motor's status. The light can shine RED or
GREEN. Here is an overview of the possible combinations.
LED flashes
after switch-on
LED flashes
after reset
LEDs flash during
battery-powered operation
Other flashing signals
Movement sequences
One short movement (1×)
Two short movements –
action refused
Three short movements
Four short movements
Start / Restart
Vertical unit, slats arranged on left
Vertical unit, slats arranged on right
Vertical unit, split arrangement
Reset end positions
Reset network via Motor button
Low battery level. The unit will run slowly.
Extremely low battery level.
The blind unit will not run any more.
Maximum motor voltage has been reached
(obstruction)
The motor is in programming mode
Action confirmed
Reset end positions
Closed end position invalid
Open end position invalid
Action refused when setting the open end
position
Action refused during end position setting
EN