MHZ PowerView Surface Kit Manual De Instrucciones página 28

Vertical Blind Programming Guide
PowerView® I
Set end positions (set closed end position)
28
Press Motor button and keep
pressed.
Additionally, press Close
button.
Make sure that the desired
channel has been set on the
remote control.
Release Motor button.
Using the Move buttons, move
the blind into the desired end
position.
Press Stop button for 6 seconds
(do not select a channel button
on the remote control unit)
Blind briefly moves once.
Caution: Stop the unit
before reaching the me-
chanical end position.
Button lighting on the
trans mitter flashes.
Teach-in readiness
established.
Continues on next page