MHZ PowerView Surface Kit Manual De Instrucciones página 29

Vertical Blind Programming Guide
PowerView® I
Set end positions (set closed end position)
+
Press Motor button and keep
pressed.
Additionally, within 3 seconds,
briefly press Close button .
Release Motor button.
If the buttons are still flashing,
the remote control unit is still in
'Teach-in Readiness' mode.
Press Stop button for 6 seconds
or wait for 20 seconds.
The closed end position has
now been set.
EN
Blind briefly moves once.
Button lighting on the
transmitter stops flashing.
Teach-in readiness ended.
To set the closed end
position again, repeat the
steps.
29