Setting The Auto Power Standby Function; Initializing The Unit - Yamaha SRT-700 Manual De Instrucciones

Setting the auto power standby function

By enabling the auto power standby function, you can avoid forgetting to turn off the unit
after use, or if you fall asleep while watching TV.
NOTE
• When the auto power standby function is enabled and one of the following conditions is met, the unit will
automatically turn off.
− No operations for 8 hours
− No audio input and no operations for 20 minutes when BLUETOOTH is selected as the input source.
1
With the unit turned off, hold down the MUTE key on the unit's
remote control for more than 3 seconds to enable/disable the auto
power standby function.
You can check the status of the auto power standby function with the indicators on
the front panel for several seconds right after the unit is turned on.
Off (enabled), lights up (disabled)
HINT
• Initial setting varies depending on the country or region.
− U.K. and Europe models: enabled
− Other models: disabled
14

Initializing the unit

Follow the procedure below to initialize the unit.
1
Turn off the unit.
2
Hold down (power) on the front panel of the unit for more than 3
seconds.
Flash (initialized)