Important Instructions For Use; Heating Power - therm-ic Heated Beanie Modo De Empleo

Regulate: Each time the control button "+"
button is pressed (approx. 1 sec.),
the heat level is increased; with the
"–" button (approx. 1 sec.), you can
lower the heat level. The LEDs on
the heat level display show the
current heat level (1 LED = low
heat, 3 LEDs = high heat).
I M PO R T A NT I NS T R U C T I O N S FO R US E
 Recharge the battery before each use.
 Make sure that the battery have been connected
correctly with the hat (connector latched).
 When starting up, do not allow step 3 to be
switched on longer than a few minutes in each
case, otherwise too much heat can be produced
during operation – danger of burning.
 Always set your Therm-ic Heated Beanie to level
1 or 2 to maintain a comfortable level of warmth
for your ears (heating should be almost
undetectable).
 An optimum heat level can been reached when
13
the hat is dry.
H E A TI N G P O WE R
Max.
Level
temperature*
(°C / °F)
1 30°C / 86°F
2 38°C / 100°F
3 50°C / 122°F
* Measured directly on the heating element under
laboratory conditions
The heating duration per charge depends on the
selected heating level, the ambient temperature
and the age as well as charging status of the
batteries.
Heating period
per battery
charge
5 – 6 hours
2.5 – 3 hours
1.5 – 2 hours