Connections - Yamaha YST-SW015 Manual De Instrucciones

Caution: Plug in the subwoofer and other audio/video components after all connections are
completed.
Connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier.
● To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L/MONO INPUT terminal of the subwoofer.
Right main speaker
Amplifier
Notes
● Some amplifiers have line output terminals labeled PRE
OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier
has at least two sets of PRE OUT terminals. If the
amplifier has only one set of PRE OUT terminals, do not
connect the subwoofer to the PRE OUT terminals.
4
E-

CONNECTIONS

Subwoofer
INPUT
AUTO PHASE
/MONO
STANDBY
OFF LOW HIGH NORM REV
110V–120V 220V–240V
VOLTAGE
SELECTOR
POWER
ON
OFF
To AC outlet
● When connecting the subwoofer to the SPLIT
SUBWOOFER terminals on the rear of the DSP amplifier,
be sure to connect the L/MONO INPUT terminal to the
"L" side and the R INPUT terminal to the "R" side of the
SPLIT SUBWOOFER terminals.
INPUT
AUTO PHASE
/MONO
STANDBY
OFF LOW HIGH NORM REV
SPLIT SUBWOOFER
SUBWOOFER
(LOW PASS)
● When connecting to a monaural line output terminal of
the amplifier, connect the L/MONO INPUT terminal.
Left main speaker
Subwoofer cable
(not included)
Audio pin cable
(not included)