Program The Monitors; Ads Digital Directory; System Features; Operation - Fermax 6078 Manual De Instrucciones

9. Program the monitors

HIGH RESOLUTION
CCD CAMERA
PAN &TILT
AUDIO DATA SYSTEM
1. Enable programming mode.
Audio call must be generated.
Pick up the handset and tell the
a s s i s ta n c e y o u r s i t u a t i o n
(appartment). Hang up.
Checkings
Make a call to the programmed monitor to verify that audio and video communication is
established.
Audio and video communication must be finished by hanging up.
Time between steps 1 and 2 must never be greater than 2 minutes.
JP1 must be set to its original position after programming the monitor to disable
programming mode.
Install and program the other monitors.

ADS Digital Directory

S Y S T E M F E A T U R E S :
S Y S T E M F E A T U R E S :
AUDIO DATA SYSTEM
O P E R AT I O N
AUDIO DATA SYSTEM
1
2
4
3
5
7
6
8
A
9
0
2. Dial number to assign and press bell key.
Call must be generated to indicate the
successfully ending of the process. Pick up
handset, check audio and hang up again.
ADS Digital Directoy is only avaliable with Kits Ref. 6143/6144.
1
2
4
3
5
7
6
8
A
9
0
3 . D i s a b l e p r o g r a m m i n g
mode.
%
%
Pag 21