Display Symbols; Standby Mode - Terraillon Petit MultiThermo 50 Manual Del Usuario

72-T24MN-012 150506-01.qxd 5/19/2006
D I S P LAY SYMBOLS
Scanning
Ear Mode
Forehead Mode
Temperature higher than 50°C
Temperature lower than 10°C
Memory. Last Temperature Reading
Clock
Reading in Celsius
This symbol appears when the battery is low.
The thermometer can still be used, but when
you see the symbol "Lo " , the battery should
be changed because the thermometer can no
longer function properly.
Ambient operating temperature (16-40°C) out
of range
If the " " or " " is blinking and you hear a
beeping signal, the thermometer is not ready for
use. Push one of the buttons then wait for the
symbol to stop blinking.
S TAND BY MODE
The thermometer goes into standby
automatically after 30 seconds of inactivity.
10
5:43 PM Page 10
M A I N T E N A N C E
Clean thermometer sensor with a cotton swab
moistened with alcohol before and after each
usage. Do not use abrasive cleaners. Do not
submerge thermometer in water or any other
liquid because only the sensor is waterproof.
P R E C A U T I O N S
1. Use of this thermometer is for monitoring
purposes only and is not intended as a
diagnostic tool. Make sure that any unusual
readings are communicated to your
physician. Under no circumstances should
you change your prescribed medicine doses.
2. Do not grip strongly, drop, or crush
thermometer.
3. Keep out of reach of children.
4. Keep thermometer away from direct sunlight
and store well away from any source of heat
in a clean, dry location.
5. Do not submerge thermometer in water or
any other liquid because only the sensor is
waterproof.
6. M u l t i t h e rmo 50 is only meant for taking
temperatures in the ear, on the forehead and
in the room. Do not use for taking rectal, oral,
or axillary temperatures.
7. Do not touch the sensor lens with fingers.
8. Do not take temperature within 30 minutes of
eating, exercising, or taking a bath.
9. Wait one minute between each temperature
reading. Two readings right after each other
can give slightly different measurements.
Should this occur, use the average of the two.
How to choose the temperature measuring
G UA R A N T E E
unit (Fahrenheit F° or Celsius C°)?
This unit is guaranteed for 2 years against any
When the appliance is turned off: press button " "
material or manufacturing defects. During this
to start it up. The F° and C° symbols will appear
period, any such defects will be repaired free of
charge (proof of purchase must be furn i s h e d
on the screen. Rapidly press button " " (before
for each claim). This guarantee does not cover
the last recorded temperature comes onto the
damage due to accidents, improper use, or
screen) to change from one measuring unit to the
negligence. Should you like to make a claim,
o t h e r. The thermometer is ready for use when the
please first contact the store where you made
m e m o ry symbol " " is displayed.
your original purchase.
M A N U FA C T U R E R
This Multithermo 50 probe is antibacterial and
has been tested by an approved laboratory.
AVITA CORPORATION
No.200.205 Provincial
Free way Song Ling Town,
Wu Jiang City,
Jiang Su, P .R.C. ZIP:215200
C E O 1 9 7
TECHNICAL
Applied Standard.
S P E C I F I C T I O N S
1. ASTM E 1965-98
Operating temperature range: 10°C - 50°C
2. EN 980:1997 (Graphical Symbol)
Tolerance level: between 36 and 39°C: +/- 0.2°C
3. IEC/EN 60601-1 (Safety)
Below 36°C: +/- 0.3°C
4. IEC/EN 60601-1-2 (EMC)
Above 39°C: +/- 0.3°C
5. EN 1441:1997 (Risk Analysis)
Graduation: 0.1°C
Operating conditions: 16 to 40°C 15-95% RH
Storing conditions: -20 to 50°C 15-95% RH
Battery: 1 x 3V CR2032
11