Cequent Performance Products 65076 Instrucciones De Instalación página 5

5. Install bottom fasteners: Feed the coiled end of the fish wire o through the
attachment hole in the bottom of the frame and out toward front frame rail access.
Attach the carriage bolt j and spacer n to the fish wire o and pull the fish wire
with fasteners into location through the hole. Leave fish wires attached. Repeat
the same process on the both frame rails.
7. Install hitch: Raise the hitch into position being careful of the cooling lines on passengers side. Feed the fish wires through the slots/holes on the brackets. Feed the
receiver tube through the trimmed hole in the air dam, if trimmed. Line up the holes in hitch side bracket with holes in skid plate and frame rail. Pull side carriage bolt j
one at a time back through the frame rail, skid plate and hitch bracket. Feed conical washer l over fish wire, using the washer to hold the bolt in place, remove the fish
wires and attach the hex nut m. Tighten to hold hitch in place, repeat on all fasteners. See Figure 1
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Install side fasteners: Feed the coil end of the fish wire o through one of the
holes on the side of the skid plate and into the frame rail, then back out the side of
the frame rail. Attach the carriage bolt j and spacer k to the fish wire o and
pull the fish wire with fasteners into location through the hole. Leave pull wires
attached. Repeat the same process on remaining hole. Repeat the same process
on the both frame rails. Push fasteners back into frame rail leaving the fish wire
exposed. NOTE: If the skid plate bracket is not present use the spacers (item 7)
between the frame rails and hitch, both sides.
Sheet 5 of 18 65076NP 1-4-18 Rev. B