Stages cycling Stages Power L Manual Del Usuario página 10

Linking Left and Right Power Meters
If a single sided power meter is purchased as an addition to an existing single
sided power meter, the two must be linked together to perform as a LR unit.
mobile app and ensure the power meters are awake by rotating the cranks.
1. Open the Stages Power app on your compatible mobile device.
2. Select the left and right side power meters from the discoverable
devices list and then hit Connect.
3. From the main screen, select Link to connect the two sensors. Units
Note: Once two meters are linked as a LR unit, only the left power meter's
ANT+ ID will be visible.
4. To use the power meters separately, repeat this process and select
Unlink from the main screen of the app.
Troubleshooting
Error Codes
An error code may be displayed if the zero reset or calibration fails. Please
note the possible error codes below and corrective action that should be
taken.
Code #s Corrective Action
Simply attempt zero reset again. If code remains after several
1, 2, 4,
attempts, please contact technical support.
16
Power meter crank not in proper position (vertical), see page 5.
32
If no power (watts) or cadence (RPM) signal is being received by your
items:
1.
power meter. See diagrams on pages 3-4.
2. Ensure that the power meter has been successfully paired to the display
3.
powered on and functional.
10