Dimplex DF2624L-EU Manual De Instrucciones página 3

DF2624L-EU
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
When using electrical appliances, basic
precautions should always be followed to reduce
the risk of fire, electrical shock and injury to
persons, including the following:
If the appliance is damaged, check with the
supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a
bath, shower or swimming pool.
Do not locate the appliance immediately below a
fixed socket outlet or connection box.
The appliance carries the Warning symbol
DO NOT COVER, indicating that it must
not be covered.
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use
of the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by Children without supervision.
Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that
it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use
of the appliance in a safe way and understanding
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user
maintenance.
Do not use this appliance in series with a
thermal control, a program controller, a timer
or any other device that switches on the heat
automatically, since a fire risk exists when the
appliance is accidentally covered or displaced.
Ensure that furniture, curtains or other
combustible material are positioned no closer
than 1 metre from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for long
periods.
Although this appliance complies with safety
standards, we do not recommend its use on deep
pile carpets or on long hair type of rugs.
The appliance must be positioned so that the
plug is accessible.
If the supply cord is damaged it must be replaced
by the manufacturer or service agent or a
similarly qualified person in order to avoid a
hazard.
Keep the supply cord away from the front of the
appliance.
Warning: In order to avoid overheating, do not
cover the appliance. Do not place material or
garments on the appliance, or obstruct the air
circulation around the appliance, for instance
by curtains or furniture, as this could cause
overheating and a fire risk.
Warning: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
CAUTION - Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
General
Unpack the heater carefully and retain the packaging for
possible future use, in the event of moving or returning the fire
to your supplier. The fire incorporates a flame effect, which can
be used with or without heating, so that the comforting effect
may be enjoyed at any time of the year. Using the flame effect
on its own only requires little electricity.
Before connecting the heater check that the supply voltage is
the same as that stated on the heater.
Please note: Used in an environment where background noise
is very low, it may be possible to hear a sound which is related
to the operation of the flame effect. This is normal and should
not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the
voltage marked on the heater must correspond to the supply
voltage. Before switching on, please read the safety warnings
and operating instructions.
Product Setup - see Fig. 4
1. Unpack the firebox and the front glass panel
2. Remove the glass retaining bracket from one side of the
fire box as shown in Fig. 4.
3. Slide the glass into the glass support track on both the
top and bottom, until it is fully inserted.
4. Replace the glass retaining bracket as per Fig. 4.
Controls - see Fig. 2 & 3
The four controls shown below are found on both the product
and the remote control:
On/Standby Button.
Flame On/Off Button- This cycles the flame effect options
Flames & Logs On / Flames On & Logs Off / Flames Off
& Logs On / Flames and Logs Off. Please note the heater
can be used independently of the flame effect.
Heat Cycle Button- Press once for heat, press a second
time to turn the heat off. Each successful input will be
indicated by a beep, in addition to the beep the 'Heat'
symbol will appear for 5 seconds after selection in the
floating display shown in Fig. 1.
Sleep Timer Button- to set the product to automatically
shut off after a pre-set amount of time (from 30minutes
to 8 hours) Pressing the timer button will increase the
length of time until the product shuts off by increments
of 30minutes. The 'Sleep Timer' symbol and timer can be
seen for 5 seconds after selection in the floating display as
shown in Fig 1. NOTE: The Sleep Timer can be cancelled
by repeatedly pressing the 'Sleep Timer Button' until the
timer displays nothing.
EN