Connecting A Hunter Solar Sync Et Sensor; Installing Solar Sync Sensor; Installing The Wireless Solar Sync; Solar Sync Settings - Hunter X-CORE Manual Del Usuario

EN

CONNECTING A HUNTER SOLAR SYNC ET SENSOR

The X-Core is compatible with the Solar Sync and Wireless Solar
Sync systems. Solar Sync is a sensor system that will automatically
adjust the X-Core controller's watering schedule (based on changes
in local climate condition) by using the Seasonal Adjust function.
The Solar Sync uses a solar and temperature sensor to determine
evapotranspiration (ET), or the rate at which plants and turf use
water, and also includes Hunter Rain Clik and Freeze Clik technology
that will shut down irrigation when it rains and/or during freezing
conditions.
NOTE: Solar Sync will apply a default seasonal adjust
value of 100% until the first full day (24 - hour period)
of weather measurements have been received from the
sensor.
NOTE: Enabling the Sensor Bypass switch has no effect
on the seasonal adjust updates from the Solar Sync
sensor. It will, however, bypass the Rain Clik and Freeze
Clik functionality of the sensor.
NOTE: The Solar Sync module is not required for
installation using the X-core Controller.

Installing Solar Sync Sensor

Connect the Green and Black wire from the Solar Sync Sensor to the
"SEN" wiring terminals on the X-Core
controller, similar to picture on page 11.
It does not matter which wire connects
to which terminal. Turn the dial to the
"Solar Sync Settings" position. The
display will initially show dashed lines
14
and then will show the default Region setting (3) on the left and
the default Water Adjustment setting (5) on the right. Adjust the
Region as needed by using the
for explanation of Solar Sync Region setting). Use the
advance to the right to adjust the Water Adjust setting as needed
(see page 14 for explanation of Water Adjust setting).

Installing the Wireless Solar Sync

Connect the Green and Black wire from the Wireless Solar Sync
Receiver to the "SEN" wiring terminals on the X-Core controller. It
does not matter which wire connects to which terminal. Turn the
dial to the "Solar Sync Settings" position. The display will initially
show dashed lines and then will show the default Region setting
(3) on the left and the default Water
Adjustment setting (5) on the right.
Adjust the region as needed by using
the and buttons (refer to page
13 for explanation of Solar Sync Region
setting). Use the button to advance
to the right to adjust the Water Adjust setting as needed (see page
14 for explanation of Water Adjust setting).

Solar Sync Settings

Once the Solar Sync sensor is connected to the X-Core controller,
two numbers will appear in the display when the dial is turned to the
Solar Sync Settings position. The number on the left of the screen is
the Region setting, and the number on the right on the screen is the
Water Adjustment setting (as shown above).
and buttons (refer to page 13
button to