Publicidad
Idiomas disponibles
Idiomas disponibles
Assembling the Mask
1.
Attach the swivel coupling to the mask elbow.
2.
Insert nasal pillows into cushion. NOTE: Pillows can be attached by their lower groove (Tallest
Height Position) or their upper groove (Shortest Height Position) in order to optimize your seal.
3.
Attach the cushion to the mask shell.
4.
Attach headgear by snapping the buckles of the headgear onto the posts on the mask shell.
5.
Attach the circuit tube from the CPAP or Bi-level ventilation system to the swivel coupling.
PILLOW HEIGHT OPTIONS
(inserting a pillow into the cushion)
Tall Position
(insert into
lower groove)
Putting on the Mask
1.
Clean and thoroughly dry your face before putting on the mask.
2.
Insert the pillows into your nose and then rotate the mask down over your mouth. NOTE: The
upper wall of the cushion should sit above your mouth on your upper lip.
3.
Pull the headgear back over the top of your head.
4.
Turn on CPAP or Bi-level system and make sure it is functioning properly. Connect the mask.
Adjusting the Mask
1.
Unhook the hook-and-loop closures of each of the five headgear straps individually and gently
pull until the mask sits squarely on your face. The mask should fit snug enough to prevent
large leaks yet still be comfortable. In general, a looser fit is better. Over-tightening may
actually make leaks worse.
2.
Breathe normally, and continue making minor adjustments until you have a comfortable fit with
minimal leaks. If you are unable to achieve a comfortable fit or to resolve any leaks around the
mouth, you may need an alternative cushion size. If you are unable to achieve a comfortable
fit or to resolve any leaks at the nose, you may need an alternative pillow size.
3.
To remove the mask, you do not need to unhook each strap. Just unsnap the buckles of the
headgear from the mask, and then lift the mask off over your head.
Cleaning Instructions – Homecare Applications
After Each Use:
1.
Remove the headgear from the mask; it will be washed separately.
2.
Disassemble swivel coupling and cushion from the mask. Remove pillows from the cushion.
OR
Short Position
(insert into
upper groove)
PUTTING ON THE MASK
1. Insert
pillows
2. Rotate mask
3. Adjust
headgear
Publicidad
