Descargar Imprimir esta página

bosal 7-pin Manual De Instrucciones página 4

Ocultar thumbs Ver también para 7-pin:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Draw end of bunch with brown, white/green, black/green and grey/green leads to right standing lights:
6.
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
7.
Draw remaining end of bunch with 6-input joints to left standing lights:
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
8.
Place 6-input joint behind left side casing in boot.
Connect additional control set in vehicles with light installation control using 6-input connection built in bunch.
This connection is not used in vehicles without light installation and bridge connection shall not be disconnected.
Additional set for electric installation control
Vehicles without reversing control system (APS):
9.
Leave white/green lead not connected in boot. Cut the end off and insulate the lead.
White/green lead cannot touch vehicle ground.
10.
Vehicles with reversing control system (APS):
a) Reversing control driver is located under right standing lights
b) Connect 16-input plug to module and unfasten secondary blockade from casing,
c) Dismantle end from container no. 5 (red/white lead) and assemble end with white/green lead in this place,
d) Reassemble casing and connect it to the driver.
11.
Trailer power supply:
Refer to 13-pin version. 3-pin connector housing (red/blue, yellow, white/brown, white/brown cables) is provided
for expanded socket functions. Put this part of cable set behind the trim. To expand socket functions it is necessary
to order the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth"
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing
device.
article no. 014-199
part no. 014-169
part no. 015-069

Publicidad

loading

Este manual también es adecuado para:

13-pin