Cadillac LWB Splash Guard - Rear
Please read instructions thoroughly before starting.
Installation Time
Approximately 30 minutes.
Tools Required
T15 Torx Screw Driver
Drill
1/8" (3.0 mm) Drill Bit
Clean Cloth/Rag
Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
M4.2 x 20 Self-tapping Screw
U-nut
Alcohol Prep-Wipes
Instruction Sheet
Installation Procedure
1. Remove rear tire.
2. Clean and degrease body panel where splash guards are
to be located.
3. Clean area where tape will contact body parts with Alcohol
Prep-Wipe.
4. Remove three screws (A), (B) and (C). Hold the splash
guard in position against the rear fascia and install the
supplied M4.2 x 20 screws. Make sure the splash guard
5. Remove the tape liner from the inside edge of the splash
seconds. See Fig. 2
Drill a 1/8" (3.0 mm) hole at location (D) and install the
M4.2 x 20 screw along with u-nut (used as a nut) into the
new hole location (D). The u-nut should be located behind
7. Repeat procedure for the other side.
8. Guards can be cleaned with any commercially available
cleaner.
Splash Guard - Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
07AU15
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
8
2
2
1
See Fig. 1
See Fig. 3
REVISION
Initial Release - Vinay Saini
SELF-TAPPING
SCREWS
FIGURE 2
FIGURE 3
IR 07AU15
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
2278184
Cadillac LWB Rear Splash Guard
PART NO.
84001668
FIGURE 1
C
B
A
SPLASH
GUARD
VIEW FROM
U-NUT
BELOW
D
DRILL
HERE
SELF-TAPPING SCREW
84001668
PART NO.
SHEET
TAPE
LINER
D
1
3
SHEET
OF
1
3
OF