Features; Operation Instructions - Urrea UP125 Manual De Usuario Y Garantía

IMPORTANT: Air powered tools can vibrate
in use. Vibration, repetitive motions or un-
comfortable positions may be harmful to your
hands and arms. Stop using any tool if discom-
fort, tingling feeling or pain occurs. Seek medi-
cal advice before resuming use.
• Never operate a Percussion Tool unless an ac-
cessory is properly installed and the tool is held
firmly against the work.
• Always use a retainer, when furnished, in ad-
dition to proper barriers to protect persons in
surrounding or lower areas from possible eject-
ed accessories.
• This tool is not designed for working in ex-
plosive atmospheres.
• This tool is not insulated against electric
shock.
• Prevent exposure and breathing of harmful
dust and particles created by power tool use:
Some dust created by power sanding, sawing,
grinding, drilling and other construction activi-
ties contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some
examples of these chemicals are:
- lead from lead based paints,
- crystalline silica from bricks and cement and
other masonry products, and
- arsenic and chromium from chemically treat-
ed lumber.
Your risk from these exposures varies, depend-
ing on how often you do this type of work. To
reduce your exposure to these chemicals: work
in a well ventilated area, and work with ap-
proved safety equipment, such as those dust
masks that are specially designed to filter out
microscopic particles.
• Do not indulge in horseplay. Distraction can
cause accidents.
• Keep hands and fingers away from the throt-
tle lever until it is time to operate the tool.
• Never point the tool at anyone.
• Compressed air is dangerous. Never point an
air hose at yourself or co-workers.
• Never blow clothes free of dust with com-
pressed air.
• Be sure all hose connections are tight. A loose
hose not only leaks but can come completely
off the tool and while whipping under pres-
sure, can injure the operator and others in the
area. Attach safety cables to all hoses to pre-
E N G L I S H •
vent injury in case a hose is accidentally bro-
ken.
• Never disconnect a pressurized air hose. Al-
ways turn off the air supply and bleed the tool
before disconnecting a hose.
• Know what is underneath the material being
worked. Be alert for hidden water, gas, sewer,
telephone or electric lines.
• Use only proper cleaning solvents to clean
parts. Use only cleaning solvents which meet
current safety and health standards. Use clean-
ing solvents in a well ventilated area.
• Do not flush the tool or clean any parts with
diesel fuel. Diesel fuel residue will ignite in the
tool when the tool is operated, causing dam-
age to internal parts. When using models with
outside triggers or throttle levers, take care
when setting the tool down to prevent acci-
dental operation.
• Do not operate the tool with broken or dam-
aged parts.
• Never start the tool when it is lying on the
ground.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
2
3
1. NEEDLES (19 PC)
2. NEEDLE HEIGHT CONTROL.
3. AIR INLET.
4. TRIGGER SWITCH.

OPERATION INSTRUCTIONS

LUBRICATION
Always use an air line lubricator with these
tools. We recommend a Filter-Lubricator-Reg-
ulator Unit.
U se r's m a n ua l
1
4
7