Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
5
4
1. BATTERY POWERED GREASE GUN.
2. GREASE CONTAINER (500 cc).
3. HIGH PRESSURE HOSE.
4. GREASE DISPENSER.
5. QUICK CHARGER.
6. BATTERY (x2).
OPERATION INSTRUCTIONS
PRODUCT FEATURES
· 8 500 PSI, Output Grease Pressure
· Grease Output upto 3 oz. (85 g/minute) in
free flow.
· Automatic Air Bleeder & Bulk Loader
· Automatic Pressure Release Valve.
· 30"-High Pressure Hose with Spring Guard
on both ends (prevents hose from kinking).
· High Pressure Grease Coupler.
· An additional 1.5Ah Ni-Cd Battery Pack for
un-interrupted greasing.
· One hour quick charger (each battery charge
provides power to dispense upto 6 Grease
cartridges in free flow condition).
3
2
1
6
E N G L I S H •
CHARGING THE BATTERY PACK
For best performance, do not recharge the new
battery unless it is completely discharged. Re-
charging the battery pack before its complete
discharge will reduce the total work life of the
pack. All New guns come with 80% charge
from the factory and no charging is needed
until it is used and the battery is run down.
As a battery pack approaches the discharged
state, the tool performance drops. This is the
right time to recharge the battery pack. Re-
charging the battery pack before this condi-
tion is reached will reduce the total work life
of the pack. Discharging the pack beyond this
point can damage the pack.
• Before using Grease Gun for the fist time, if
the battery pack is installed in the gun, remove
it by depressing the two battery release but-
tons (one button on each side of battery pack)
and pull battery pack out of gun.
IMPORTANT: Battery temperature will
increase during and shortly after use. Allow
the battery pack to cool to room temperature
before charging otherwise batteries may not
accept a full charge.
• Insert the Battery
Pack into the Charg-
ing
Socket
of
the
Charger. Then, plug
the Charger into the
nearest,
grounded,
electrical outlet.
• To start charging,
press the "Set" button
on the Charger.
A green light indicates that the battery is
charging. After termination of the charging
(approx. 1-2 hours), pull charger out of socket
and remove battery.
GETTING STARTED
1. Removing empty cartridge: Remove any
cartridge in the grease gun barrel prior to re-
filling. To check if a cartridge is in the barrel,
first compress the spring by pulling the plunger
handle fully outward & latch the plunger rod
in the slot on the end cap. Remove the grease
gun head by turning it anticlockwise to remove
any empty cartridge.
2. Locking / Releasing the plunger rod: This
gun incorporates a groove in the plunger rod
U se r's m a nua l
SET
11
Publicidad
Tabla de contenido
