ARIETE 2786 Manual De Instrucciones página 12

EN
HEPA exhaust filter cleaning/replacement
The exhaust air filter needs cleaning on a regular basis and it should be replaced every 6 to 9 months,
depending on use.
- Open the bag division pushing the apposite lever outside (FIG. 7).
- Take the filter out of its housing (FIG.11) and shake it vigorously to clean it. If the filter is extremely
soiled, wash it with lukewarm soapy water and leave it to dry. NEVER use artificial means to dry
the filter. To replace the filter, contact an Assistance Centre.
- Insert the filter again inside its seat; be sure that the coarse surface of the filter is visible.
TROUBLESHOOTING
Thermal cutout switch
The vacuum cleaner is equipped with a thermal cutout switch to protect it in the event that the
mots tor overheats. If the vacuum cleaner suddenly switches off by itself, proceed as follows:
- Switch off the vacuum cleaner and unplug it from the mains power.
- Look for the origin of the overheating (blocked suction pipe, dirty filter, etc.)
- Clean the pipe, empty the dust bag, and clean the filter, if necessary.
- Wait for about 30-40 minutes to allow the motor to cool down.
- After 30-40 minutes, insert the plug in the mains socket and switch on the vacuum cleaner.
The vacuum cleaner should now work.
- If the vacuum cleaner still does not work, wait another 20 minutes and then try again.
- If the cleaner still does not work, contact an Assistance Centre.
- 10 -