bosal 005-338 Manual De Instrucciones página 4

Disconnect 7-way connector in vehicle right tail lamp and join it with fitting connector from cable set,
7.
a) Connect remaining connector from cable set to right tail lamp connector.
Put the end of cable set marked L inside the rubber seal of boot cover and bring to the left tail lamp:
8.
a) Disconnect 7-way connector in vehicle left tail lamp and join it with fitting connector from cable set,
b) Connect remaining connector from cable set to the left tail lamp connector.
Connect brown and white
9.
the eyelet terminal with sheet metal screw, do not secure the hole with anti-corrosion remedy).
10.
Trailer power supply:
Refer to 13-pin version only. 3-pin connector housing (red/blue, yellow, and white/brown cables) is provided for ex-
panded socket functions. Put this part of cable set behind the trim. To expand socket functions it is necessary to or-
der the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth"
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during instal-
lation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing de-
vice.
cables (only in 13-pin sets) to earth (for instance drill the 3mm hole and connect and fix
part no. 014-169
part no. 015-069