Bimar TEKNOTORRE Folleto De Instrucciones página 9

Fax +32 030 9904733
ASSEMBLY
Attention: the fan can only be used if complete with the support base.
Attention: always unplug the appliance before you assemble to the fan.
The fan can only be used if complete with the support base. To assemble it, refer to fig. assembly: first
screw on the back shell, then the front, and inset the electric cord through the guide, making sure to lock it
with the screws provided.
Assembly
Control panel
1. Timer button
2. Auto button
3. Oscillation button
4. Style button
5. On/Off button
6. Speed button
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
The fan's functions can be controlled either with the keypad located on the control panel or with the
remote control. The remote control must be pointed at the control panel; for the first use take off the tab
transparent plastic of the batteri's side (type CR2032).
Insert the plug in the socket.
Ventilation:
To turn the fan on, press the "ON/OFF" key on the remote control or the control panel. The fan will
start at the minimum speed.
To select the desired speed, repeatedly press the "SPEED" key: on the control panel shows the
selected speed (minimum, medium or maximum).
Horizontal oscillation (right-left): this is controlled by the "OSC" key on the remote control or the
pushbutton panel.To eliminate this motion, press the "OSC" key again.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
A. Tower fan
B. Attachment screws
C. Rear shell
D. Front shell
Remote control
1. Timer button
2. Auto button
3. Oscillation button
4. Style button
5. On/Off button
6. Speed button
7. Ion button
9 24
/
Assembly page 9/24