Before The First Use - Domo DO936DVK Manual De Instrucciones

BEFORE THE FIRST USE

INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth
and the inside with a wet, lukewarm cloth. Avoid placing the cabinet in a narrow recess
or near any leave source, direct sunlight, or moisture. Let air circulate freely around the
cabinet.
· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your freezer.
· Before connecting your freezer to the power supply, check that the voltage stated on the
rating label of your appliance corresponds to the voltage in your home. A different voltage
could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that
may occur as a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant
can settle.
· Allow the appliance to run empty for 24 hours so the compartment can cool to the
appropriate temperature.
· This appliance is designed to operate in ambient temperature between 16°C and 38°C.
If these temperatures are exceeded, i.e. colder or warmer, the appliance will not operate
correctly.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.
USE
TEMPERATURE CONTROL
The freezer is controlled with a temperature control knob located inside the appliance. Adjust
the control knob as desired to suit your individual preference. The higher the number, the
colder the temperature. In the OFF position the appliance does not operate (the cooling
system is switched off), but power supply is not interrupted.
· The running time and temperature are affected by where the freezer is located, how often
the door is opened and the temperature of the room the freezer is located in.
· When you use the appliance for the first time or after defrosting, adjust the control knob
to the coldest setting for at least 2 hours before introducing food to be stored, and then
readjust to the desired setting.
www.domo-elektro.be
33
DO936DVK