Safety Instructions - XCLEAR Surface Handheld Manual

SAFETY INSTRUCTIONS

This device generates harmful UV-C radiation. Direct contact is harmful to the eyes and skin. Check
the operation of the UV-C lamp only with protected equipment. Everyone involved in work on or
with the UV system must be aware of the dangers and harmfulness of UV-C radiation.
1. Warning: The use of this product is not suitable for children and/or persons (including children)
with reduced physical, sensory or mental capabilities or lack of experience and knowledge,
unless they are supervised or instructed in the use of the device by a person responsible for
their safety.
2. Warning: To reduce the risk of electric shock, replace damaged equipment immediately.
3. To reduce the risk of electric shock, the appliance must be handled with care. As experience
and knowledge are required, service activities should always be performed by an authorised/
recognised technician.
4. Never touch the device if it falls into water! Unplug the device from the power outlet. If the plug
and/or socket have also become wet, isolate the socket from the power supply before removing
the plug. Disconnect the connection cable before removing the unit from the water. Since
electrical components are damaged by water and therefore become unsafe, the device should
be presented to an authorised/recognised technician for inspection.
5. Do not switch on the unit if it has been dropped by transport or otherwise, if a production fault
exists or the device has been damaged by any other cause (this applies in particular to the UV-C
lamp!).
6. Always connect the device to an undamaged and earthed electrical socket equipped with a
residual current device.
7. Always unplug the appliance when it is not in use and/or during (cleaning) work. To remove the
plug from the wall socket, always pull on the plug itself. Never pull on the cable.
8. To avoid the risk of electric shock, do not insert or unplug the power plug with wet hands and/
or while standing in water.
9. Never immerse all or parts of the unit in water or any other liquid.
10. The cable of the unit must not be shortened and/or directly connected without a plug. If the
cable is damaged, the entire unit must be handed over to authorised/recognised technicians.
Devices with cut/shortened cables are not covered by the warranty.
11. When the device is switched off, the light source will stay warm for at least ten minutes. Before
replacing a light source, check that it has cooled down sufficiently to prevent burns.
12. Use of the unit other than for its intended or developed purpose is not permitted. Using the
appliance other than for the purpose for which it was developed by the manufacturer may lead
to unsafe situations.
13. This device may only be operated in accordance with the guidelines described in this manual. In
addition, you must adhere to the instructions attached to the appliance.
14. Always wear protective gloves when handling or replacing the light source. This is to avoid
fingerprints on the glass.
15. Radiation from this UV lamp is dangerous for the eyes and skin. All persons involved must be
informed of the specific dangers associated with this UV-C system.
| SURFACE
10