Sound Settings And Setup Menu; Changing The Sound Settings; Adjusting The Sound Characteristics; Enjoying Sophisticated Sound Functions - Advanced Sound Engine - Sony DSX-S200X Manual De Instrucciones

Sound Settings and Setup Menu

Changing the sound settings

Adjusting the sound
characteristics
1
During reception/playback, press the
multi way encoder.
2
Rotate the multi way encoder until the
desired menu item appears, then
press it.
3
Use the multi way encoder to select
the setting, then press it.
4
Press (BACK).
The setting is complete and the display
returns to normal reception/play mode.
The following items can be set:
The operation of the multi way encoder will
differ depending on the items.
: Push the multi way encoder up/down
: Push the multi way encoder left/right
: Rotate the multi way encoder
EQ7 Preset (page 23)
EQ7 Parametric Tune (page 23)
Listening Position Front/Rear (page 24)
Listening Position Subwoofer (page 24)
Listening Position Custom Tune (page 25)
Fader & Balance
Front/Rear/Center (
Adjusts the relative level.
Right/Left/Center (
Adjusts the sound balance.
Subwoofer Tune & LPF
Phase ( )
Selects the phase: "Normal," "Reverse."
FREQ ( )
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz," "120Hz."
Slope ( )
Selects the LPF slope: "1," "2," "3."
Subwoofer Level (
Adjusts the subwoofer volume: "+10 dB" –
"0 dB" – "–10 dB."
("– ∞" is displayed at the lowest setting.)
HPF
FREQ ( )
Selects the cut-off frequency: "off," "50Hz,"
"60Hz," "80Hz," "100Hz," "120Hz."
Slope ( )
Select the HPF slope: "1," "2," "3."
DM+ Advanced (page 25)
Rear Bass Enhancer (page 25)
)
)
)
Dynamic Loudness (page 25)
Enjoying sophisticated sound
functions — Advanced Sound
Engine
Advanced Sound Engine, Sony's new sound
engine, creates an ideal in-car sound field with
digital signal processing. Advanced Sound
Engine contains the following features: EQ7,
Listening Position, DM+ Advanced, Rear Bass
Enhancer, Dynamic Loudness.
Selecting the sound quality — EQ7
Preset
You can select an equalizer curve from 7
equalizer curves ("Xplod," "Vocal," "Edge,"
"Cruise," "Space," "Gravity," "Custom" or
"off").
1
During reception/playback, press the
multi way encoder.
2
Rotate the multi way encoder until
"EQ7 Preset" appears, then press it.
3
Push the multi way encoder up/down
until desired equalizer curves
appears, then press it.
4
Press (BACK).
The display returns to normal reception/play
mode.
To cancel the equalizer curve, select "off" on step
3.
Tip
Adjusted equalizer curve settings can be memorized
separately for Tuner and USB (SensMe™) sources.
Customizing the equalizer curve
— EQ7 Parametric Tune
"Custom" of EQ7 allows you to make your own
equalizer settings.
Select "Custom" of EQ7 Preset.
If you set "off" for EQ7 Preset, "EQ7 Parametric
Tune" does not appear in the sound settings
menu.
1
Select a source, then press the multi
way encoder.
2
Rotate the multi way encoder until
"EQ7 Parametric Tune" appears, then
press it.
continue to next page t
23