Trust GXT 31 Manual De Instrucciones página 4

GXT 31 Gaming Mouse - USER'S MANUAL
Mouse layout
- Button 1. (left mouse button, not programmable)
- Button 7. (default function = triple mouse click)
- Button 3. (default function = middle click)
- Button 2. (default function = right mouse click)
- Button 4. (default function = page forward)
- Button 5. (default function = page backward)
- Mode button (click to switch between 'Profile-1,2,3,4 and 5')
Installation
- Insert the Trust CD-ROM into your CD drive.
- Click "Run Setup.exe – Published by Trust International BV"
- Click "Install driver".
- Click 'finished' when the installation is finished.
- Connect the mouse to the USB port of the PC.
- Wait until the message 'Your device is ready to use' appears.
- Start the mouse configuration software. (located in the taskbar)
- You can now start to configure the mouse.
- In the following part of the manual there be refered to the 'OK' function that updates the mouse.
'OK' is located in the bottom right corner of the main window.
(the mouse will stop working when it's beeing updated. This will take a few seconds.)
The mouse can store 5 different profiles. You can instantly switch between these setups by pressing the 'Mode'
button on the mouse.
You don't need to click on 'OK' after every single change. You can make all the changes that you want and then
click 'OK' to update all changes directly to the mouse.
Profile settings
(The mouse can store 5 different profiles)
Changing a profile
- Click on 'Profile'
- Click on the profile that you want to change.
Enable or disable profiles
- Click on 'Mode Name/Select'
- In the 'Mode Administration' window you can change profile names and enable or disable profile.
- To disable a profile,un-tick each profile from the bottom to the top order; to add a profile tick each
profile in reverse order.
2