Denver SC-17 Manual Del Usuario página 2

Installation
This chapter provides instructions to install the video baby monitor.
At the first use, please recharge the battery inside the parent unit by using the
power adapter.
The baby unit has a lens cover. Please remove this lid before you start to use the
ALERT video baby monitor.
Before placing the camera in a definitive way (baby unit) it is advisable to check the proper
functioning of equipment and proper radio communication between parent unit and baby unit.
1.Connect the 5VDC – 1.000 mA power adapter to parent unit.
The power socket (DC5V
unit.
The parent unit has a rechargeable battery, so
when it is charged enough, you can use the device
without the power adapter. For more details please
NOTE
refer to the parent unit chapter.
2.Press the power button
in the left side will light ON. The display will show as picture
below:
3.Connect the 5VDC – 1.000 mA power adapter to Baby Unit
(wireless camera). The power socket (DC5V
the back side.
The wireless camera can use 3 x AAA batteries
(not included). For more details please refer to
Baby Unit chapter
NOTE
4.Press and hold the POWER ON/OFF button for 5-6 seconds
until the LED will flashing in red colour. This means that the
pairing phase is started.
5.With a thin object, such as a paper clip, press the RESET
button on the back side of the parent unit, the display should
show the images and you can hear the sound picked up by the
microphone inside the wireless camera.
Now you can turn off the camera and place it in
the final place. For next use is no longer necessary
to repeat the pairing phase.
) is in the left side on parent
, the green power LED available
Parent Unit – LCD panel
ENG 1
ENGLISH
Parent Unit – Power adapter
Parent Unit – Power ON
) is in
Baby Unit – Power adapter
Baby Unit – Power ON
Parent Unit - Pairing