Parent Unit - Battery - Denver SC-17 Manual Del Usuario

ENGLISH
The pairing phase must be completed within 30 seconds. If you are unable to
complete its on time, wait until the red LED on the camera stays light ON, then
turn off the camera and try again. Once successfully completed there is no need
NOTE
to repeat the pairing phase.
Description
This chapter provides a description of parent unit and baby unit.
Parent Unit - Description
2
3
4
1
5
6
10
7
8
9
Parent Unit – Talk and Listen function
This appliance has a dual connection between parent unit and baby unit (2 ways). This means
that you can speak with your baby by talking in the microphone inside the parent unit and your
voice will be heard by the baby through the speaker inside the camera, so you can calm him
without moving.
To talk with your baby please follow these steps:
1.Please check if the wireless camera is active then power ON the parent unit.
2.Press and hold the TALK button then start to speak near the parent unit.
3.Release the TALK button to listen your baby.
1.Power button (ON/OFF)
2.LCD Panel
3.Channel radio (1-2-3-4)
4.TALK button
5. and OK buttons
6.Speaker
7.RESET button
8.Left side: power connector and LED
9.Right side: AV OUT connector
10.Clip
11.Radio signal strength icon
12.Channel icon
13.Battery charge icon
LCD Panel
11
12
13
ENG 2
Parent Unit – Volume
To set the volume in the parent unit, please follow these steps:
1.Power ON the parent unit.
2.Press or buttons and select your desired volume level. It is possible to set a volume level
from 0 to 9. The selected value will be stored in the parent unit.
If you select "0" (zero) the audio in the parent unit will be disabled.
If the parent unit is near the baby unit you could hear a noise as "whistle". To
fix this inconvenience please place the wireless camera far from parent unit or
NOTE
decrease the volume.
Parent Unit – Radio signal strength
The LCD panel shows the radio signal strength icon.
Good signal. This is the optimal condition to use the appliance.
Low signal. There is communication between parent unit and baby unit, but you
risk to loose the signal. It is recommended to change the position of baby unit or
decrease the distance between parent unit and wireless camera.
No signal. There is not any communication between parent and baby unit.
Parent Unit – Battery
The parent unit has inside a rechargeable battery. At the first use it is recommended to fully
charge the battery by connecting the power adapter to parent unit and fit it in a compatible
power outlet.
Full charge. The battery life is approximately 5 hours.
Low charge. The battery is very low and therefore will need to connect the power
adapter soon.
Completely discharged battery. Charge the battery by connecting the parent unit
to the power adapter.
Parent Unit – Main menu
To enter in the main menu, power ON the parent unit and press the OK button.
Listed below the options available:
1.ZOOM IN/OUT
2.BABY UNIT VOLUME
3.EFFECT SET
4.SETUP
5.TV OUT
Press or buttons to select an option and press OK button to confirm the selection.
ENGLISH
ENG 3