Technical Data; Preparations At The Workplace - Hilti HDE 500­A12 Manual De Instrucciones

• Use only Hilti Li-ion batteries of the B12 series with this product. For optimum performance, Hilti
recommends the batteries stated in the table at the end of these operating instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
Dispenser and operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Charge state display
The charge state of the Li­ion battery is displayed after pressing one of the release buttons lightly (press only
until slight resistance is felt).
Status
4 LEDs show.
3 LEDs show.
2 LEDs show.
1 LED shows.
1 LED flashes.
4

Technical data

Weight without battery
Rated voltage
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
6 English
Meaning
Charge state: 75 % to 100 %
Charge state: 50 % to 75 %
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
• Charge state: < 10 %
Battery charge state cannot be displayed while the
control switch is pressed and for up to 5 seconds
after releasing the control switch.
2330325
*2330325*
HDE 500-A12
1.8 kg
(4.0 lb)
10.8 V
−40 ℃ ... 85 ℃
(−40 ℉ ... 185 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
10.8 V
See the end of these
operating instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−40 ℃ ... 85 ℃
(−40 ℉ ... 185 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)