HoMedics enviraScape Manual De Instrucciones página 5

WFL-SLVSA-2EU_IB.qxd:Layout 1
5. Fill FOUNTAIN BASE (K) with enough clean water to completely cover the
WATER PUMP (F). Use the Fill Line as a guide. (Figure 5)
6. Place RIVER ROCKS (J) as desired on (A), (B) and (C), as well as in the FOUNTAIN BASE.
(Figure 6)
7. Attach the ADAPTER (I) to the POWER CORD (G).
8. Plug the cord into 230V household outlet. The fountain is controlled by an
ON/OFF SWITCH (H) located on the POWER CORD (G). If WATER PUMP (F)
does not operate, rotate in-line switch once to turn "ON" and once to turn "OFF".
NOTE: Ensure that the POWER CORD loops below the electrical outlet to form a
"Drip Loop". This will prevent water from running down the POWER CORD into the electrical
outlet. (Figure 7)
Figure 5
9/11/10 15:06
Fill Line
Figure 7
Drip Loop
Page 5
Figure 6
Stones
5