Hotpoint Ariston KBH 6034 DO/HA Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Installation
 Before operating your new appliance please read this
GB
instruction booklet carefully. It contains important
information concerning the safe operation, installation
and maintenance of the appliance.
 Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning
 Keep all packaging materials out of the reach of children.
It may present a choking or suffocation hazard (see
Precautions and tips).
 The appliance must be installed by a qualified
professional in accordance with the instructions provided.
Incorrect installation may damage property or cause harm
to people or animals.
Built-in appliance
Use the appropriate cabinet to ensure that the appliance
functions properly.
• The supporting surface must be heat-resistant up to
a temperature of approximately 100°C.
• If the appliance is to be installed above an oven, the
oven must have a forced ventilation cooling system.
• Avoid installing the hob above a dishwasher: if this
cannot be avoided, place a waterproof separation
device between the two appliances.
• Depending on the hob you want to install, the
cabinet must have the following dimensions (see
figure):
Ventilation
To allow adequate ventilation and to avoid overheating
of the surrounding surfaces the hob should be positioned
as follows:
8
.ixing
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could change
the features and the operation of the hob.
• At a minimum of
40 mm from the
back panel and
600 mm from any
other vertical
surfaces.
• So that a minimum
distance of 10 mm is
maintained between the
Distance to
installation cavity and the
keep between the
cut-out slot and
cabinet underneath.
the cabinet
REAR SPRING ASSEMBLY
HOB FROM BELOW
Above an empty cabinet or a drawer
A space of at least 40 mm, or an opening of 5 mm on
the width measurement of the cabinet, should be created.
Opening of at least 5 mm
on the overall width
measurement of the surface.
FRONT OF HOB
KITCHEN
WORKTOP
40mm

Publicidad

Tabla de contenido
loading

Tabla de contenido