RadioOperation; SelectingARadioBand; SelectingAFrequency - Jensen MP1516 Manual Del Propietário

RADIOOPERATION

SelectingaRadioBand

Press the SRC button on the faceplate or the MODE button on the remote control
to select radio mode. The radio frequency appears in the display panel together
with the frequency memory band (FM1, FM2, FM3, AM1 or AM2).
The unit has five preset memory bands - three FM Bands (FM1, FM2, and FM3) and
two AM Bands (AM1, and AM2) selects. Each of the five bands can store up to six
preset stations, for a total of 30 preset memory stations.

SelectingaFrequency

In radio mode, press the BAND/ID3 button on the faceplate or the Band button
on the remote control briefly to select the desired band. The reception band will
change in the following order:
F1 F2
(FM1) (FM2)
RadioTune/SeekFunction
In radio mode, press and hold the SEEK
display panel will show "MANU SEEK". Press the SEEK
manually adjust the radio frequency.
Tuning
Press the SEEK
clear frequency station. Repeat to seek more stations in your listening area with a
strong signal.
Mono/StereoReceptionControl
The reception of distant stations may be improved by selecting "MONO"
operation. "MONO" operation may cut down some reception noise.
In FM radio mode, press the SEL button until "MONO" appears on the display
1.
panel.
2. Rotate the volume knob to select STEREO or MONO.
Local/DistantControl
The local and distance reception setting can improve radio reception, depending
on the location where the radio is being used.
In FM radio mode, press the SEL button until " LOCAL" appears on the display
1.
panel.
2. Rotate the volume knob to select "LOCAL" or "--DX--".
24
F3 AM1
(FM3) (AM1)
or button once. The radio will seek the next strong and
AM2
(AM2)
or button for 2 seconds, and the
or button once to