Sears Kenmore 69272 Manual De Uso Y Cuidado página 5

Handle_
SO_'ew
Handle
trim
Snap handle trim into place. Replace 3 plugs in
empty mounting holes.
2. Remove top hinge cover. Top hinge cover snaps off.
Remove top hinge and hinge shim using hex nut
driver.
3. Remove refrigerator door by lifting door off of center
hinge pin.
4. Remove center hinge pin using hex nut driver.
5. Remove freezer door by lifting door off bottom hinge.
An internal support rod may slide out of hinge socket.
Replace rod before hanging door.
6. Remove center hinge bracket and hinge shim using
Phillips screwdriver.
7. Remove toe grille and bottom hinge cover. Both snap
off.
8. Remove bottom hinge and hinge shim using hex nut
driver.
5/16 screws__ _"9
Top hinge
3/8" or
5/16"
hex nut L_ center hinge
_pin
_f"_'_-.._Z-,--Center hinge
Center hinge // _'_1 bracket
Phillips screws_
_
Bottom hinge
3/8"
screws
g.
Remove freezer door handle.
• Pry up back edge of handle cap using a putty knife
with the blade covered in masking tape. Remove
handle cap from handle. Remove handle from door
by removing mounting screw at each side of
handle.
• Remove 2 plugs from hinge side of door.
10.
Handle
cap
ws
Plug
Reverse doors by performing the following steps:
• Remove plugs and screws from opposite side of
refrigerator cabinet. Insert in holes left from hinge
removal.
• Replace internal support rod in hinge side of freezer
door before to hanging door.
Suppo_
_d
11. Rehang doors by replacing bottom, center, and top
hinges, along with freezer and refrigerator doors on
opposite side d refrigerator performing steps 2-8 in
reverse order.
Use a penny at top to space door 3/4"(18 mm)
from cabinet.
Handle side of door should be approximately
_/8"(3 mm) higher than hinge side. Door will
become level when it is loaded with food.
5