Dash Disassembly - Metra 95-7877 Instrucciones De Instalación

1. Unclip and remove the lower
center panel below radio.
(Figure A)
2. Remove (1) 8 mm bolt facing up
behind center panel.
Note: Slide the recirculation
control lever to FRESH for better
access to bolt. (Figure A)
3. Open the upper glove box then use
a pry tool to unclip and remove the
radio/climate control assembly.
(Figure B & C)
4. Remove (2) Phillips screws
securing the hazard switch to the
back of the factory radio panel.
(Figure D)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
95-7877
5. Remove (2) Phillips screws
securing the air bag light to the
back of the factory radio panel.
(Figure E)
6. Remove (5) Phillips screws
securing the A/C vents to the
radio panel.
7. Remove (7) retaining clips from
radio housing to be used later in kit
preparation.
Continue to kit assembly
2
(Figure D)
(Figure E)