Kit Assembly - Metra 95-7877 Instrucciones De Instalación

Kit preparation
1. Secure the hazard switch into the
radio housing panel using the
factory hardware. (Figure A)
2. Secure the air bag light into the
radio housing panel using the
factory hardware. (Figure A)
3. Secure the A/C vents to the
radio housing using the factory
hardware. (Figure B)
4. Attach the (7) retaining clips to the
radio housing panel in the same
location as removed from the
factory radio panel.

Kit Assembly

(Figure A)
(Figure B)
95-7877
Double DIN radio provision
1. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
2. Snap the Double DIN brackets
to the inside edge of the radio
housing. (Figure A)
3. Slide the Double DIN radio or
stacked ISO radios into the bracket/
radio housing assembly and secure
the Double DIN radio or stacked
ISO radios to the assembly using
the screws supplied with the radio.
(Figure B)
4. Snap the Double DIN trim plate
onto the front of the radio/housing
assembly. (Figure B)
5. Re-assemble dash in reverse order
of disassembly.
3
(Figure A)
(Figure B)