Scott A6 2019 Manual Del Usuario página 6

AUS/NZ DIRECTIVES : SCOTT BIKE HELMETS COMPLY WITH THE PROTECTIVE MEASURES AND SECURITY REQUIREMENTS
IN ACCORDANCE WITH AS / NZS 2063-2008. ALL HOMOLOGATED HELMETS BEAR CORRESPONDING SEALS STATING THAT
ALL OFFICIAL TESTS HAVE BEEN PASSED. THE SEALS ARE EASILY VIEWABLE AND MAY NOT BE REMOVED.
THE LABEL INSIDE THE HELMET CONTAINS FOLLOWING INFORMATIONS
WARNING ! THE END USER SHOULD CAREFULLY READ THE INSTRUCTION
BEFORE USING THE PRODUCT (PPE).
MANUFACTURING DATE : YEAR-MONTH / INDIVIDUAL SERIAL NUMBER.
THE CE MARKING ENSURES COMPLIANCE WITH THE ESSENTIAL
REQUIREMENTS OF REGULATION EU 2016 / 425.
INDICATES COMPLIANCE WITH EN 1078, A EUROPEAN HARMONIZED STANDARD REGARD-
EN 1 078
ING HELMETS FOR PEDAL CYCLISTS AND FOR USERS OF SKATEBOARDS AND ROLLER SKATES.
ICON INDICATES THE SPECIFIC SPORT FOR WHICH THE PROTECTOR IS DESIGNED TO
BE USED : NOT FOR MOTOSPORTS.
INDICATES COMPLIANCE WITH THE STANDARD SAFETY REQUIREMENTS OF THE
UNITED STATES CONSUMER PRODUCT SAFETY COMMISSION.
DO NOT REMOVE THE LABELS ON THE INSIDE OF THE HELMET.
DO NOT USE CLEANING PRODUCTS ON THE HELMET. USE ONLY SOAP AND
WATER TO CLEAN THE HELMET.
DO NOT USE PETROLEUM-BASED SOLVENTS OR AUTOMOTIVE WAX TO CLEAN
OR POLISH THE HELMET.
FRONT
INDICATES THE DIRECTION OF THE FRONT OF THE HELMET.
WEIGHT INDICATIONS ARE DEFINED WITHOUT ACCESSORIES INTER ALIA INNER LINING.
WWW.SCOTT-SPORTS.COM
©SCOTT SPORTS SA 2018. ALL RIGHTS RESERVED. REV. 01 OF 03.2018. THE INFORMATION CONTAINED IN THIS
MANUAL IS IN VARIOUS LANGUAGES BUT ONLY THE ENGLISH VERSION WILL BE RELEVANT IN CASE OF CONFLICT.
WARNING THIS PRODUCT CAN EXPOSE YOU TO CHEMICALS INCLUDING BISPHENOL A, WHICH IS KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. FOR MORE INFORMATION GO TO
WWW.P65WARNINGS.CA.GOV
ENGLISH - 10
• AS STICKER - INSTRUCTION FOR USE AND CARE
DESIGNED TO MEET ALL IMPACT TESTING REQUIREMENTS OF: AUSTRALIA / NEW ZEALAND AS / NZS 2063:2008
WARNING
• THIS HELMET CONFORMS TO THE AS / NZS 2063: 2008 STANDARD FOR BICYCLE HELMETS. THIS HELMET IS NOT
INTENDED FOR MOTORSPORT USE.
• NO HELMET CAN PROTECT THE WEARER AGAINST ALL POSSIBLE IMPACTS.
• THE HELMET IS DESIGNED TO BE RETAINED BY A STRAP UNDER THE LOWER JAW.
• TO BE EFFECTIVE, A HELMET MUST FIT AND BE WORN CORRECTLY. TO CHECK FOR CORRECT FIT, PLACE HELMET ON
HEAD AND MAKE ANY ADJUSTMENTS INDICATED. SECURELY FASTEN RETENTION SYSTEM. GRASP THE HELMET
AND TRY TO ROTATE IT TO THE FRONT AND REAR. A CORRECTLY FITTED HELMET SHOULD BE COMFORTABLE AND
SHOULD NOT MOVE FORWARD TO OBSCURE VISION OR REARWARD TO EXPOSE THE FOREHEAD.
• NO ATTACHMENTS SHOULD BE MADE TO THE HELMET EXCEPT THOSE RECOMMENDED BY THE HELMET MANUFACTURER.
• THE HELMET IS DESIGNED TO ABSORB SHOCK BY PARTIAL DESTRUCTION OF THE SHELL AND LINER. THIS DAMAGE
MAY NOT BE VISIBLE. THEREFORE, IF SUBJECTED TO A SEVERE BLOW, THE HELMET SHOULD BE DESTROYED AND
REPLACED EVEN IF IT APPEARS UNDAMAGED.
• THE HELMET MAY BE DAMAGED AND RENDERED INEFFECTIVE BY PETROLEUM AND PETROLEUM PRODUCTS,
CLEANING AGENTS, PAINTS, ADHESIVES AND THE LIKE, WITHOUT THE DAMAGE BEING VISIBLE TO THE USER.
• A HELMET HAS A LIMITED LIFESPAN IN USE AND SHOULD BE REPLACED WHEN IT SHOWS OBVIOUS SIGNS OF WEAR.
• THIS HELMET SHOULD NOT BE USED BY CHILDREN WHILE CLIMBING OR DOING OTHER ACTIVITIES WHERE THERE
IS A RISK OF HANGING OR STRANGULATION IF THE CHILD GETS TRAPPED WHILST WEARING THE HELMET.
HEAT CAN DAMAGE THE HELMET. IN DIRECT SUNLIGHT, DARK GEAR BAGS AND AUTOMOBILE TRUCKS CAN GET HOT
ENOUGH TO CAUSE HEAT DAMAGE. DAMAGED HELMETS WILL APPEAR TO HAVE UNEVEN OR BUBBLY SURFACES. DO
NOT USE HEAT DAMAGED HELMETS.
DISTRIBUTION AUSTRALIA / NEW ZEALAND :
SHEPPARD CYCLES, PO BOX 62067, NZ-1644 AUCKLAND, TEL: +64 9 915 5770
AUSTRALIA/NEW ZEALAND STANDARD AS/NZS 2063:2008 BICYCLE HELMETS LIC
BSI BMP 599047
ISSUED BSI BY
BENCHMARK
AUSTRALIAN STANDARD AS/NZS 2063
ISSUED BY SAI GLOBAL PEDAL CYCLE HELMETS
SAI SMK 02623
11 - ENGLISH