THOMSON ROC330 Manual De Instrucciones página 2

ROC 330 7/05/99 23:08
This Universal Remote Control is compatible with most models of infrared-controlled TV sets,
video recorders, LVD players, satellite and cable TV receivers.
This remote control was programmed in the factory, so that you can use it to control most of
the sets of the THOMSON group's make. For this reason, we recommend that prior to
attempting to programme the remote control, you try it out by means of one of the methods
described in this user manual. But first of all, you'll have to load the supplied batteries into
the remote control.
Please keep this guide along with the code list (provided separately), so that you can
subsequently programme your remote control for use with other sets.
Standby key.
1
Videotext: Yes/No.
2
Videotext: to stop scrolling pages.
3
RECORD: keys printed in grey in these Instructions have the same functions as those of your VCR, your
4
original remote control or your DVD DTH 1000/2000/2500 THOMSON.
To record, press the RECORD key twice.
STOP
5
REW
6
Direction keys for vertical travelling through the menus.
7
ZOOM-, ZOOM+: for horizontal travelling through the menus (with sets supporting this feature).
8
To access the menus.
9
- PROG +: allows you to access the channels (received by your TV set, video recorder or satellite receiver)
10
in either ascending (+) or descending (-) order.
When videotext is active, these coloured keys can be used to select headings, depending on the set's make.
11
For selecting an external source.
12
Indicator lamp: the red indicator lamp lights up when any key is pressed.
13
Videotext: Info key.
14
Videotext: Back to TV programme.
15
PAUSE
16
Programming of the remote control.
17
PLAY
18
F.FWD
19
OK: To confirm a selection.
20
EXIT: To leave the menus.
21
Switches the TV sound off.
22
- VOL +: to increase (+) or decrease (-) the volume of the TV set.
23
Number keys 0 to 9: these keys have the same functions as those of your original remote control and
24
are used to enter the codes of your different sets.
Press this key first, before you type in the 2-digit channel number.
25
TV, VCR, SAT: use these keys to select the set you want to control.
26
2 - Testing the not yet programmed remote control
1. Switch on the set you want to control.
2. Position the selector (26) on the type of set to be controlled:
TV: television set
VCR: video recorder
SAT: satellite receiver
3. Direct the remote control towards the TV set and try to switch it off by simply
pressing the key B B (1).
Should the set not switch off, you'll have to programme the remote control by
means of one of the methods A, B, C or D described hereinafter in chapter 3.
Page 1
1 - Description of the key functions
1