Yakima 8000226 Guia De Inicio Rapido página 2

Remove cover from Landing Pad.
Use assembled to determine
placement on vehicle.
With the Control Tower cover open, mark the outline
of the holes on the vehicle roof with a #2 pencil.
1033033A-2/12
Attach Control Tower to Landing Pad
Arrange Towers on canopy from
front to back and side to side. Place
Towers considering the following:
NOTE: IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE
PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER SUCH AS A QUALIFIED
GARAGE OR AUTO BODY SHOP.
Center punch
the holes.
Use eye
protection!
Close cover.
• Design and strength of
construction of vehicle.
• Compatibility of
accessories and crossbar
spread requirements.(See
side bar).
• Easy access to loaded
accessories.
Drill 1/8"
pilot holes.
Do not drill through Landing Pads.
CROSSBAR REQUIREMENTS:
The distance between the
Yakima crossbars is
determined by the accessories
you wish to carry.
Refer to the instructions for the
accessory to determine how
much crossbar spread your
accessories require.
• Drill final hole size
with 1/4" drill bits.