Product Marking - Siemens ECHOMAX xps Manual De Instrucciones

The certification of this equipment relies on the following materials used in their construction:
Enclosure
Encapsulant
1.
Kynar®is a registered trademark of ELF Atochem.
Durapot®is a registered trademark of Cotronics Corporation.
For manual override, use the disconnect switch provided in the building installation of the
associated controller.
XPS 30/40 Series – Certificate SIRA 01ATEX5153X
This equipment may be used in hazardous dust zones with all conductive and non-conductive
dusts. The XPS-30 and XPS-40 type series transducers have a maximum surface temperature
of 135 °C (275 °F) (Temperature Class T4). These units are certified for use in ambient range of
-40 to 95 °C (-40 to 203 °F). The transducers should not be used outside this temperature range.
The XPS-30 and XPS-40 ultrasonic transducers must be installed so the face of the transducer
is not substantially subjected to light.
Installation shall be carried out in accordance with the applicable code of practice, and by
suitably trained personnel. Repair of the equipment shall be carried out in accordance with the
applicable code of practice and installation instructions.
These devices should only be supplied from a circuit containing a suitably rated fuse that has a
breaking capacity of 4000A. This fuse is included in Siemens Milltronics controllers.
The certification of this equipment relies on the following materials used in their construction:
Enclosure:
Kynar®710
Encapsulant: Stycast LA-9823-76
For manual override, use the disconnect switch provided in the building installation of the
associated controller.

Product Marking

Kynar®polyvinylidene flouride is resistant to attack from most chemicals under the
Note:
described operating conditions. However, for exposure to specific environments, check
with chemical compatibility charts prior to installation.
WARNING:
23/EC and is not intended for use as a safety device.
XPS-30
7ML19985QM82 XPS/XCT Series Transducers – OPERATION MANUAL
XPS Series
1
Kynar® 710
Stycast LA-9823-76
This product is designated as a Pressure Accessory per Directive 97/
XCT Series
Kynar®710
Durapot® 861-F3 & 864
Page EN-3