Candy FCL 614/6 GH Instrucciones De Uso página 13

USE OF ANALOGUE CLOCK/PROGRAMMER
OPERATION SPECIFICATION
GENERAL OPERATION
The analogue clock programmer displays the time and operation of
the oven. By pushing the control knob you can:- Adjust the time,
program the start and end time of cooking or set the Minute Minder
alarm.
SETTING THE TIMER
To adjust the time on the clock press the knob 4 times until the
"CLOCK" symbol flashes. To adjust the time, turn the control knob
either clockwise or counter clockwise. After adjustment is complete
wait for 10 seconds and the electronic timer will automatically set the
time.
MANUAL COOKING
In the default mode, the timer allows manual operation of the oven
using the main oven switch (external to the timer).
ATTENTION: When power is supplied to the oven timer, there is a
delay of a few seconds.
SETTING THE MINUTE MINDER
Minute Minder programming enables you to set an audible alarm to
sound after a scheduled time without activating the cooking.
To set an "alarm" (Minute Minder Mode), press the knob 3 times until
the symbol "ALARM" flashes.
Minute minder setting is identical to end of cooking timer settings (see
corresponding paragraph).
It is only possible to use the Minute Minder when no other cooking
program is active.
SEMI AUTOMATIC COOKING:
SWITCH OFF AT A SET END TIME
End of cooking programming enables you to start cooking
immediately and stop cooking automatically at a set time.
To program the end of cooking time, press the knob twice until the
"END TIME" symbol flashes. To increase or decrease the cooking
time, turn the knob either clockwise or counter clockwise. The "END
TIME" symbol continues to flash for a few seconds after the last
rotation. The program is confirmed by pressing the knob.
Upon confirmation of the program, cooking starts and the alarm is
automatically activated.
Cooking stops when the the programmed "END TIME" is achieved.
To view the program press and release the knob and the timer will
show the selected program.
When cooking stops the "END TIME" symbol flashes and the alarm
beeps. The alarm will beep for 1 minute and the "END TIME" symbol
will remain flashing until the knob is pressed.
STOP
TIMER
CLOCK
START
To cancel the program, press the knob for a few seconds and the
program will be cancelled, the timer will return to manual cooking
mode.
FULLY AUTOMATIC COOKING
Cooking start programing enables to you start and stop cooking
automatically based on the time scheduled.
To program the cooking start time, press the knob once until the
flashing of the "START TIME" symbol.
Increase or decrease the cooking start time by turning the knob
clockwise or counter clockwise.
continue to flash for a few seconds after the last rotation. If within this
time you do not turn or press the knob the hands will automatically
return to display the time and the program is cancelled. If you press
the knob the cooking start time is stored ("START TIME" symbol is
turned on) and the timer switches to cooking end programming (the
"END TIME" symbol flashes)
The cooking time end programming will follow the procedure in the
preceding section.
Cooking will begin when "Programmed Start Time equals Preset
Time".
BLACKOUT INDICATION (OPTIONAL)
The "Clock" symbol will flash when the power supply has been
interupted.
To stop it flashing briefly press the control knob.
13 GB
The "START TIME" symbol will