Bosch GSH 27 Instrucciones De Servicio página 9

Tool Specifications
Demolition Hammer
Order number
Rated power*
Output power*
Impact rate under load [bpm]
Impact energy
per stroke
Tool holder
Weight (without
accessories) approx.
Protection class
* The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific
countries, these values can vary.
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Inrush currents cause short-time voltage drops. Under un-
favourable power supply conditions, other equipment may
be affected. If the system impedance of the power supply
is lower than 0.36 Ohm, disturbances are unlikely to occur.
Noise/Vibration Information
Measured values determined according to
2000/14/EC (1.60 m height, 1 m distance away)
and EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 91 dB (A); sound
power level: 104 dB (A).
Wear hearing protection!
The typical weighted acceleration is 13 m/s
Machine Elements
1 On/Off switch
2 Handle grips
3 Tool retainer
4 Tool holder
5 Tool shank
6 Shoulder
Not all of the accessories illustrated or described are
included as standard delivery.
Intended Use
The machine is intended for heavy chiselling and
demolition work as well as for driving and com-
pacting with the appropriate accessories.
9 • 1 619 929 583 • TMS • 25.02.02
GSH 27
0 611 304 1..
[W] 1 900
[W] 1 260
1 030
[J] approx. 60
1
[mm / "] 28 / 1 /
8
[kg] 27
/ II
2
.
English - 1
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
Wear hearing protection.
Wear a protective helmet.
Wear safety glasses, protective gloves and
sturdy shoes.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open via
a residual current device (RCD) with an actuat-
ing current of 30 mA maximum. Use only exten-
sion cables that are approved for outdoor use.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assistance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
Hold the power tool only by the insulated
gripping surfaces, when performing an op-
eration where the cutting tool may run into
hidden wiring or its own cord.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the op-
erator.
Always direct the cable to the rear away from
the machine.
Insert the mains plug only when the machine is
switched off.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Apply the machine to the surface to be worked
only when switched off.
Do not operate the machine without load.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.