Making Connections; Speaker Connection; Installing The Microphone - Sony XAV-AX1000 Manual De Instrucciones

Ocultar thumbs Ver también para XAV-AX1000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

*1 Not supplied
*2 Speaker impedance: 4 Ω – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for a wired
remote control (not supplied).
For details on using the wired remote control, see "Using
the wired remote control" (page 29).
*5 Depending on the type of car, use an adaptor (not
supplied) if the antenna (aerial) connector does not fit.
*6 Whether in use or not, route the microphone input cord
so it does not interfere with driving operations. Secure
the cord with a clamp, etc., if it is installed around your
feet.
*7 For details on installing the microphone, see "Installing
the microphone" (page 28).
*8 For more information on how to install the SiriusXM
Connect Vehicle tuner, consult the installation guide
included with the tuner.

Making connections

 To a common ground (earth) point
First connect the black ground (earth) lead then
connect the yellow and red power supply leads.
 To the +12 V power terminal which is
energized at all times
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
 To the +12 V power terminal which is
energized when the ignition switch is set to
the accessory position
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
 To the power antenna (aerial) control lead or
the power supply lead of the antenna (aerial)
booster
It is not necessary to connect this lead if there is
no power antenna (aerial) or antenna (aerial)
booster, or with a manually-operated telescopic
antenna (aerial).
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers and a
power antenna (aerial). Connecting any other
system may damage the unit.
Note
It will take about 10 seconds to shut down the output of
REM OUT after the unit is turned off.
 To a car's illumination signal
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
28
GB
 To the parking brake switch cord
The mounting position of the parking brake
switch cord depends on your car.
Be sure to connect the parking brake lead (light
green) of the power supply connection cable 
to the parking brake switch cord.
Parking brake switch cord
Hand brake type
 To the +12 V power terminal of the car's rear
lamp lead (only when connecting the rear
view camera)
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.

Speaker connection

• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 Ω to 8 Ω and
with adequate power handling capacities to avoid
damage.

Installing the microphone

To capture your voice during handsfree calling, you
need to install the microphone .
Clip (not supplied)
Foot brake type

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido